Douglas Dynamics WESTERN ENFORCER 97540 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Douglas Dynamics WESTERN ENFORCER 97540에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics WESTERN ENFORCER 97540 19 페이지. Ultramount 2 snowplow

페이지 인쇄

T-FRAME TO BLADE ASSEMBLY

1. Remove the blade wings from the metal shipping

brackets. Discard the shipping brackets and

replace the cutting edge hardware.

2. Align the hinges of the blade wings. Position the

T‑frame assembly between the blade wings so the

holes in the T‑frame are aligned with the holes in

wing hinges.

3. Insert the pivot pin from top to bottom through all

hinges as shown.

4. Move the snowplow into a normal operating

position.

Pivot Pin

Lit. No. 74914, Rev. 01

INSTALLATION INSTRUCTIONS

5/32" x 1-1/2" Cotter Pins

5. Remove the protective packaging from the angle

rams.

6. Align the holes in the rod end of the angle ram

with the corresponding holes on the back of the

blade.

Install a 1/2" x 2‑7/8" clevis pin from the top to

secure each rod to the blade. Secure the clevis

pins with 5/32" x 1‑1/2" cotter pins.

1/2" x 2-7/8"

Clevis Pins

June 1, 2020