Douglas Dynamics WESTERN ENFORCER 97540 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Снігоочисник Douglas Dynamics WESTERN ENFORCER 97540. Douglas Dynamics WESTERN ENFORCER 97540 19 сторінок. Ultramount 2 snowplow
Друкувати сторінкуT-FRAME TO BLADE ASSEMBLY
1. Remove the blade wings from the metal shipping
brackets. Discard the shipping brackets and
replace the cutting edge hardware.
2. Align the hinges of the blade wings. Position the
T‑frame assembly between the blade wings so the
holes in the T‑frame are aligned with the holes in
wing hinges.
3. Insert the pivot pin from top to bottom through all
hinges as shown.
4. Move the snowplow into a normal operating
position.
Pivot Pin
Lit. No. 74914, Rev. 01
INSTALLATION INSTRUCTIONS
5/32" x 1-1/2" Cotter Pins
5. Remove the protective packaging from the angle
rams.
6. Align the holes in the rod end of the angle ram
with the corresponding holes on the back of the
blade.
7.
Install a 1/2" x 2‑7/8" clevis pin from the top to
secure each rod to the blade. Secure the clevis
pins with 5/32" x 1‑1/2" cotter pins.
8
1/2" x 2-7/8"
Clevis Pins
June 1, 2020