Douglas Dynamics WESTERN IMPACT 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Douglas Dynamics WESTERN IMPACT에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics WESTERN IMPACT 13 페이지. Utv straight blade angle, winch lift snowplow
페이지 인쇄
4. With the angle frame parallel to the ground,
remove the wire-lock clevis pin. Fully lower the
jack stand.
Wire-Lock
Clevis Pin
5. Insert the wire-lock clevis pin in the jack stand
hole that aligns with the hole in the angle frame.
Engage the wire lock.
Jack
Stand
Lit. No. 87015, Rev. 00
INSTALLATION INSTRUCTIONS
Jack
Stand
Wire-Lock
Clevis Pin
INSTALL BLADE GUIDES
1. Secure the driver-side clamp to the outermost
rib on the driver's side of the blade using two
5/16" x 1" cap screws and 5/16" locknuts. Tighten
the fasteners to 18 ft-lb.
Driver's Side
5/16"
Locknuts
2. Remove the nut from the bottom of the blade guide.
Insert the blade guide rod into the hole in the top of
the clamp and secure it with the blade guide nut.
Passenger's Side
5/16" x 1"
Cap Screws
Blade Guide
3. Repeat Steps 1 and 2 for the passenger's side.
7
Blade Guide
Rod
Clamp
(DS)
Blade
Guide
Nut
5/16" x 1"
Cap Screws
Blade Guide
Rod
Clamp
(PS)
5/16"
Locknuts
Nut
May 15, 2021