Douglas Dynamics WESTERN IMPACT 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} Douglas Dynamics WESTERN IMPACT에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Douglas Dynamics WESTERN IMPACT 13 페이지. Utv straight blade angle, winch lift snowplow
페이지 인쇄
ATTACHING THE SNOWPLOW
WARNING
Keep 8' clear of the blade when it is being
raised or lowered. Do not stand between
vehicle and blade or directly in front of the
blade. If the blade hits or drops on you, you
could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever attaching or
detaching the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
WARNING
Keep fi ngers away from snowplow and UTV
attachment points.
NOTE: Use dielectric grease to prevent corrosion
on all connections.
NOTE: Use lubricant on connecting pins to ensure
ease of attach/detach.
1. Slowly drive vehicle forward to engage rear
headgear arms into receiver slots, bottoming out
headgear arms in slots.
Cable-Restraining
Wire-Lock Clevis Pin
Winch
Cable/Rope
Headgear
Connecting
Jack
Stand
Lit. No. 87015, Rev. 00
MOUNTING SNOWPLOW TO VEHICLE
Connecting Pin
Hole
Receiver
Headgear
Pin
Arm
2. On driver's side, pull up on headgear to relieve
pressure on connecting pins while pulling driver's
side connecting pin out. Rotate pin toward mount;
insert it into connecting pin hole.
Jack Stand
Wire-Lock
Clevis Pin
3. Verify that connecting pin is engaged in mount
(through outside and inside plates) and extends
approximately 1/8" through the plate.
4. Repeat on passenger's side.
8
Headgear
Hole in Headgear
Connecting Pin
Connecting
Jack
Pin Hole
Stand
May 15, 2021