DPI Xcel 7QP-12F950P25-C00 매뉴얼 - 페이지 5

{카테고리_이름} DPI Xcel 7QP-12F950P25-C00에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DPI Xcel 7QP-12F950P25-C00 15 페이지. 10-channel/bank 6,8,12v battery charger

wired and in good electrical condition, and large enough for the AC rating of

charger as specified in this TABLE:

EXTENSION CORDS FOR BATTERY CHARGERS

Length of cord (feet):

AWG size of cord:

 Refer to the Product ID Label affixed to the product and identify the input

requirements such as '120Vac, 60Hz, 10Amps'. Ensure that the product will

be connected to a matching utility power rating. For example; if product is

rated at 60Hz, do not connect to a 50Hz utility.

 Do not connect product to AC receptacles that share power with any other

moderate to heavy loads such as air conditioners, motors and other common

appliances. Most appliances turn on/off at random and cause power surges

and power droops that can severely affect the product connected to that

same power circuit.

 Inspect AC Receptacles for general wear, including loose or hanging

receptacles and be very aware of potentially worn contacts. If any heat is felt

in and around the receptacle while the charger is operating, this is an

immediate indication of danger caused by a worn receptacle.

4. SAFE GROUNDING INSTRUCTIONS

 Do not remove Ground Pin from charger's Power Supply AC Plug, or connect

to utility power via an adaptor that bypasses the product's ground pin

connection. The product must be grounded at all times when connected to

utility power.

 This battery charger's Power Supply must be grounded to reduce the risk of

electric shock. The Power Supply is equipped with an AC cord set having an

equipment-grounding conductor. This AC cord set must be connected to an

appropriate receptacle that is properly installed and grounded in accordance

with the National Electrical Code and all local codes and ordinances.

WARNING: IMPROPER CONNECTION OF THE EQUIPMENT-

GROUNDING CONDUCTOR CAN RESULT IN A RISK OF AN ELECTRIC

SHOCK.

 The conductor with insulation having an outer surface that is green, with or

without yellow stripe(s), is the equipment-grounding conductor. If repair or

replacement of the charger's AC cord set is necessary, refer to a qualified

service agent, and do not connect the equipment-grounding connector to a

live terminal.

WARNING: The product's supplied Power Supply is matched to the

Charger Power Requirements and may only be replaced with a

Manufacturer's Approved Power Supply.

RECOMMENDED MINIMUM AWG SIZE FOR

100

150