CardAccess ZGB20 빠른 시작 및 설치 매뉴얼 - 페이지 3
{카테고리_이름} CardAccess ZGB20에 대한 빠른 시작 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CardAccess ZGB20 12 페이지. Security sensor bridge v2
페이지 인쇄•
Drill with bits
•
Mounting screws and anchors (included)
Mounting
The bridge can be mounted on any interior wall
(protected from the elements) by following these steps:
Remove the cover by pressing in the button on
1.
the bottom of the enclosure and rocking the
cover outward.
Hold the bridge base against the mounting
2.
surface and mark the four (4) mounting holes
and two (2) wire access holes as shown in
Figure 2. Remember to leave at least 10 in. (25
cm) above the bridge for the antennas.
NOTE: The circuit board may be hinged out of the bridge base
plastics to gain better access to the mounting holes by pulling
outward on the retaining latch with a finger.
Drill holes and insert the appropriate anchors.
3.
Use the wire access holes to route the wires
4.
from the DC power supply (included) into the
bridge base.
Secure the bridge base to the wall with the pan
5.
head screws provided.
Wiring
To wire the DC power supply to the bridge, do the following:
1. Remove AC power (if applied) to the included DC power supply.
2. Wire leads of DC power supply into terminal block on the lower right side of the board. Polarity of the
wires does not matter.
3. Install metal antennas into outer slots of terminal blocks at top of board.
4. Replace cover.
Control4 Software Installation / Operation Instructions
NOTE:
DriverWorks™ drivers, which are not included with Composer software. They must be
downloaded from the Card Access website and manually installed.
Download and Install Drivers:
1. Go to
http://www.cardaccess-inc.com/automation/drivers
2.
Download the drivers you will need to use in your project.
3. Copy them to the appropriate folder on the computer you will be using to configure the project, typically "My
Documents\control4\Drivers\"
_________________________________________________________________________________________________________________________
Card Access Security Sensor Bridge V2
Quick Start & Installation Guide
The Card Access Security Sensor Bridge and GE Sensors use Control4
Figure 2 – Bridge Base Plastics
Card Access, Inc.
Page 3 of 12