CardAccess ZGB20 빠른 시작 및 설치 매뉴얼 - 페이지 4

{카테고리_이름} CardAccess ZGB20에 대한 빠른 시작 및 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CardAccess ZGB20 12 페이지. Security sensor bridge v2

페이지 인쇄

Add the Security Sensor Bridge V2 (ZGB20) to your

Composer project:

1. In System Design view in Composer, select the 'Card

Access ZGB20' driver from the Search tab and drag it into

your project (see figure at right).

2. Identification is similar to other Control4 ZigBee devices:

Go to Connections view in Composer and choose the

'Network' tab. Find the Card Access Security Sensor

Bridge device in the device list and highlight it. Then click

the 'Identify' button at the top of the screen.

3. When prompted to identify the unit, press the ID button on

the Bridge by using a paper clip inserted through the small

hole located on the face of the Bridge. Press the button

four times in succession. The 'BUS' LED on the Security

Sensor Bridge will begin blinking as it attempts to join the

ZigBee mesh and identify into the Control4 project.

4. When the Security Sensor Bridge has successfully joined

the ZigBee mesh and identified, the address of the bridge

will appear in the identification window. Click the 'Close'

button.

To add additional Security Sensor Bridges to your

Composer project:

1. When using two or more Security Sensor Bridges in the

project, you must first add one ZGB20 driver for the first

Security Sensor Bridge. Then, you will add one instance of

the Expansion Bridge driver (ZGB20-XP) for each

additional bridge.

2. Select the Card Access ZGB20-XP driver from the Search

tab. Add one instance of the Expansion Bridge driver for

each additional bridge you will use.

3. Identify each Expansion Bridge as specified in the ZGB20

instructions above. No bindings or connections to the

primary bridge are needed.

Add wireless sensors to the project:

NOTE:

wireless sensors.

1. In System Design view in Composer, select the appropriate wireless sensor driver from the Search tab

and drag it into your project.

2. Navigate to the Properties page of the wireless sensor by clicking on the newly added item on the left

pane of Composer. Note that you may need to click on another item and then back on the newly added

item to force Composer to display the Properties page for the device.

3. On the Properties page, replace the text 'unassigned' with the 6 or 7-digit TxID printed on the label on the

wireless sensor. Then click the 'Set' button.

4. Test the sensor by activating/deactivating the sensor's input. You will see the sensor status populate on

the properties page as well as the wireless signal level of the sensor-to-bridge connection.

_________________________________________________________________________________________________________________________

Card Access Security Sensor Bridge V2

Quick Start & Installation Guide

Ensure that the Security Sensor Bridge driver is added to the project before adding individual

Page 4 of 12

Card Access, Inc.