CardAccess ZGB20 Руководство по быстрому запуску и установке - Страница 4
Просмотреть онлайн или скачать pdf Руководство по быстрому запуску и установке для Беспроводная точка доступа CardAccess ZGB20. CardAccess ZGB20 12 страниц. Security sensor bridge v2
Печатать страницуAdd the Security Sensor Bridge V2 (ZGB20) to your
Composer project:
1. In System Design view in Composer, select the 'Card
Access ZGB20' driver from the Search tab and drag it into
your project (see figure at right).
2. Identification is similar to other Control4 ZigBee devices:
Go to Connections view in Composer and choose the
'Network' tab. Find the Card Access Security Sensor
Bridge device in the device list and highlight it. Then click
the 'Identify' button at the top of the screen.
3. When prompted to identify the unit, press the ID button on
the Bridge by using a paper clip inserted through the small
hole located on the face of the Bridge. Press the button
four times in succession. The 'BUS' LED on the Security
Sensor Bridge will begin blinking as it attempts to join the
ZigBee mesh and identify into the Control4 project.
4. When the Security Sensor Bridge has successfully joined
the ZigBee mesh and identified, the address of the bridge
will appear in the identification window. Click the 'Close'
button.
To add additional Security Sensor Bridges to your
Composer project:
1. When using two or more Security Sensor Bridges in the
project, you must first add one ZGB20 driver for the first
Security Sensor Bridge. Then, you will add one instance of
the Expansion Bridge driver (ZGB20-XP) for each
additional bridge.
2. Select the Card Access ZGB20-XP driver from the Search
tab. Add one instance of the Expansion Bridge driver for
each additional bridge you will use.
3. Identify each Expansion Bridge as specified in the ZGB20
instructions above. No bindings or connections to the
primary bridge are needed.
Add wireless sensors to the project:
NOTE:
wireless sensors.
1. In System Design view in Composer, select the appropriate wireless sensor driver from the Search tab
and drag it into your project.
2. Navigate to the Properties page of the wireless sensor by clicking on the newly added item on the left
pane of Composer. Note that you may need to click on another item and then back on the newly added
item to force Composer to display the Properties page for the device.
3. On the Properties page, replace the text 'unassigned' with the 6 or 7-digit TxID printed on the label on the
wireless sensor. Then click the 'Set' button.
4. Test the sensor by activating/deactivating the sensor's input. You will see the sensor status populate on
the properties page as well as the wireless signal level of the sensor-to-bridge connection.
_________________________________________________________________________________________________________________________
Card Access Security Sensor Bridge V2
Quick Start & Installation Guide
Ensure that the Security Sensor Bridge driver is added to the project before adding individual
Page 4 of 12
Card Access, Inc.