CardAccess ZGB20 Руководство по быстрому запуску и установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по быстрому запуску и установке для Беспроводная точка доступа CardAccess ZGB20. CardAccess ZGB20 12 страниц. Security sensor bridge v2

Печатать страницу

•

Drill with bits

•

Mounting screws and anchors (included)

Mounting

The bridge can be mounted on any interior wall

(protected from the elements) by following these steps:

Remove the cover by pressing in the button on

the bottom of the enclosure and rocking the

cover outward.

Hold the bridge base against the mounting

surface and mark the four (4) mounting holes

and two (2) wire access holes as shown in

Figure 2. Remember to leave at least 10 in. (25

cm) above the bridge for the antennas.

NOTE: The circuit board may be hinged out of the bridge base

plastics to gain better access to the mounting holes by pulling

outward on the retaining latch with a finger.

Drill holes and insert the appropriate anchors.

Use the wire access holes to route the wires

from the DC power supply (included) into the

bridge base.

Secure the bridge base to the wall with the pan

head screws provided.

Wiring

To wire the DC power supply to the bridge, do the following:

1. Remove AC power (if applied) to the included DC power supply.

2. Wire leads of DC power supply into terminal block on the lower right side of the board. Polarity of the

wires does not matter.

3. Install metal antennas into outer slots of terminal blocks at top of board.

4. Replace cover.

Control4 Software Installation / Operation Instructions

NOTE:

DriverWorks™ drivers, which are not included with Composer software. They must be

downloaded from the Card Access website and manually installed.

Download and Install Drivers:

1. Go to

http://www.cardaccess-inc.com/automation/drivers

Download the drivers you will need to use in your project.

3. Copy them to the appropriate folder on the computer you will be using to configure the project, typically "My

Documents\control4\Drivers\"

_________________________________________________________________________________________________________________________

Card Access Security Sensor Bridge V2

Quick Start & Installation Guide

The Card Access Security Sensor Bridge and GE Sensors use Control4

Figure 2 – Bridge Base Plastics

Card Access, Inc.

Page 3 of 12