AMS AS5 Series 운영 매뉴얼 - 페이지 4
{카테고리_이름} AMS AS5 Series에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMS AS5 Series 11 페이지. Uart programmer
AMS AS5 Series에 대해서도 마찬가지입니다: 사용자 설명서 (12 페이지)
페이지 인쇄
AS5xxx-EK-USB-PB – UART Programmer Operation Manual
1.1
Communication
The Mini-USB socket is used for communicating with the computer. Therefore, a Mini-USB to USB
cable is necessary. The board is using a FT232R – USB-to-UART IC by FTDI. Therefore the
installation of the VCP (Virtual COM Port) is necessary to detect the USB device as a COM Port.
The driver can be downloaded from the official FTDI website using following link:
http://www.ftdichip.com/Drivers/VCP.htm
1.2
Power supply
By default the 5V supply voltage is provided by the USB interface. Depending if the jumpers J3, J4
and J5 are open or closed the supply source can be switched to external power supply.
Figure 3: Jumper configuration
J3
SET
NC
ams Application Note, Confidential
[v1-20] 2014-Dec-03
J4
SET
NC
J5
Supply source
NC
External
SET
Document Feedback
USB
Page 4