Draper BDS368 사용 설명서 - 페이지 13

{카테고리_이름} Draper BDS368에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper BDS368 20 페이지. Belt and disc sander
Draper BDS368에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

CONTOUR SANDING (Fig.15):

Inside contours: Inside curves can be

sanded on the drums at either end of

the machine. Hold the work firmly, press

the contour lightly against the drum on

one side and move the work slowly

across the drum while moving up the

contour against the drum.

Outside contours: Outside curves can

be sanded on the belt table of the

unsupported side of the belt with the

table in the vertical position.

Hold the work firmly. Begin the curve

lightly against one side and feed it

across the belt towards the other side

while moving up the contour of the

workpiece.

Outside contours on the end of a

workpiece can be sanded with the

sanding disc. Feed the work lightly

against the disc and move it back and

forth from the centre of the disc to the

outside edge.

DISC SANDING (Fig.16):

Disc sanding should be done on the

outer edge of the disc which revolves

downward. Applying the workpiece to

the "UPSIDE" of the disc may cause it to

fly up, which could be dangerous to the

operator.

The mitre gauge ✳✌ is very useful as a

guide when chamfering and finishing

angle sanding.

- 12 -