Draper BDS368 사용 설명서 - 페이지 15

{카테고리_이름} Draper BDS368에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper BDS368 20 페이지. Belt and disc sander
Draper BDS368에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄
Draper BDS368 사용 설명서
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE THE PLUG
FROM THE POWER SUPPLY OUTLET BEFORE
ADJUSTING, MAINTAINING, OR LUBRICATING
YOUR BELT AND DISC SANDER.
If power cable is worn, cut, or damaged in any
way, have it replaced immediately.
Frequently blow out or vacuum out any dust
that may accumulate inside the motor.
A coat of wax polish applied to the worktable
will make it easier to feed the work while
finishing.
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH "OFF" AND REMOVE PLUG FROM THE POWER
SUPPLY OUTLET BEFORE TROUBLE SHOOTING YOUR BELT AND DISC SANDER.
TROUBLE
Motor will not run.
Machine slows down
when sanding.
Sanding belt runs off pulleys.
Wood burns while sanding.
PLEASE NOTE ALL REPAIRS/ADJUSTMENTS SHOULD BE CARRIED OUT BY A QUALIFIED PERSON.
SHOULD THE SANDER REQUIRE SENDING TO A SERVICE/REPAIR AGENT, FOR A HEALTH AND
DRAPER HELPLINE: (023) 8049 4344
MAINTENANCE
TROUBLE SHOOTING
PROBABLE CAUSE
1. Defective ON/OFF switch.
pressure to workpiece.
1. Not tracking properly.
1. Sanding disc or belt is.
SAFETY POINT, ENSURE IT IS CLEAN OF DUST AND DEBRIS.
Do not apply wax to the abrasive belt table
because the belt could pick up the wax and d
deposit it on the pulleys, causing the belt to
slip.
Keep machine clean and remove
accumulations of dust.
LUBRICATION:
The BALL BEARINGS in this machine are
packed with grease at the factory. They require
no further lubrication.
2. Burned out motor.
1. Drive belt too tight.
2. Applying too much
glazed with sap.
IMPORTANT:
- 14 -
REMEDY
1. Replace defective parts
before using belt and
disc sander again.
2. Any attempt to repair this
motor may create a
HAZARD unless repair
is done by a qualified
service technician.
1. Decrease belt tension.
2. Ease up on pressure
1. Adjust tracking, see
Operation & Use Section
"Replacing the Sanding
Belt - Tensioning and
Tracking" on page 13.
1. Replace disc or belt.