Draper BDS368 사용 설명서 - 페이지 14

{카테고리_이름} Draper BDS368에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Draper BDS368 20 페이지. Belt and disc sander
Draper BDS368에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지)

페이지 인쇄

REPLACING THE SANDING BELT AND

TRACKING (Fig.17):

WARNING - TO AVOID INJURY FROM

ACCIDENTAL STARTING, TURN THE

POWER SWITCH "OFF" AND REMOVE

THE PLUG FROM THE POWER SUPPLY

BEFORE REMOVING OR INSTALLING

SANDING BELTS.

On the inside of the sanding belt you will find

"direction arrows". The sanding belt must run

in the direction of these arrows so that the

splice does not come apart.

1. Loosen the bed locking screw ✴✌ and lift

the bed to approx. 45º, Fig.17.

2. Slide the tension lever ✵✌ to the left to

release the belt tension.

3. Place the sanding belt over the pulleys

with the directional arrows pointing in an

anticlockwise direction when looking at

the sander from the disc side. Make sure

the belt is centred on both pulleys.

4. Tension the sanding belt by sliding the

tension lever back.

5. Re-connect to the power supply. Turn

switch "ON" and immediately "OFF",

noting if the belt tends to slide off the

idler pulley or drive pulley. If the belt did

not try to slide off, it is tracking correctly.

6. If the belt moves towards the disc, turn the

tracking knob ✶✌ anticlockwise

turn, Fig.18.

7. If the sanding belt moves away from the

disc, turn the tracking knob ✶✌ clockwise

⁄

of a turn.

8. Turn the switch "ON" and immediately

"OFF" again, noting any belt movement.

Re-adjust the tracking knob if necessary.

REPLACING THE SANDING DISC (Fig.19):

With the table removed, dismantle the

sanding disc guard ✷✌ by removing the

screws. Pull off the used disc and stick the

new adhesive backed disc centrally on the

disc.

CHANGING THE DRIVE BELT (Fig.20):

Remove the single screw and take off

covering plate ✸✌. Loosen the three bolts

✹✌ and push the housing so the drive belt

becomes slack. Remove and replace the belt,

re-tension the housing so the belt is

sufficiently tight and secure housing bolts.

Refit cover ✸✌.

OPERATION AND USE

⁄

of a

Fig.17

✵✌

Fig.18

✶✌

Fig.19

Fig.20

- 13 -

✹✌

✸✌

✴✌

✷✌