ATI Audio System 10k 운영 및 유지보수 매뉴얼 - 페이지 2

{카테고리_이름} ATI Audio System 10k에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio System 10k 7 페이지. Modular amplifier rack system

SYSTEM 10K Modular Amplifier Rack System

SYSTEM DESCRIPTION

The System 10K Modular Amplifier System is a flexible and efficient high

performance audio distribution system. The System 10K combines up to ten

amplifier modules with two (redundant) power supplies in a 5-1/4" high (3RU) by

19" wide Eurocard specification enclosure that is 14-1/2" deep. All modules plug

in from the front, are hot-swappable, are secured with captive hardware and

present an attractive and safe closed front panel. Aluminum extrusion

construction makes a strong and rugged enclosure and allows free convection for

vertical airflow. The basic frame provides power bussing for all positions.

Individual modules are supplied with mating connector assemblies which mount

on the rear of the card frame and plug into the power distribution bus. Connector

assemblies provide barrier block connections with fan-out strips for studio wiring.

Alternate insulation displacement, mass termination connector systems allow

simple push-on audio connections.

A wide variety of available interchangeable plug-in modules allow an optimum

system to be initially assembled at reasonable cost and expanded and upgraded

as future requirements necessitate. A partial listing of available SYS10K modules

follows. Consult factory for latest information.

DA100

A basic one-input, six-output Distribution Amplifier--A single power stage is split

into six active balanced outputs at +22dBm each. Split and bypassed build-out

resistors give protection against short circuits and RF. Balanced bridging input.

Single front-panel level control sets all outputs. Headphone monitor jack.

MDA100

Metered 1X6 Distribution Amplifier--Adds an LED Bargraph VU Meter to the

basic amplifier described above. Measures -21 to +6 VU with 0 VU adjustable for

outputs from 0 to +18dBm. Signal Alarm indicator and output warns of dead

channel.

CDA100

Compressing 1X6 Distribution Amplifier--Adds a Gated Compressor to the

MDA100. The compressor operates on inputs above -30dBm. Compression

Slope adjustable up to 20:1. Input level sensor gates compressor gain recovery

ATI Audio Inc.

■ Tel: 856-626-3480

■

Fax: 856-504-0220

■

www.

audio.com