ATI Audio System 10k 운영 및 유지보수 매뉴얼 - 페이지 4

{카테고리_이름} ATI Audio System 10k에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ATI Audio System 10k 7 페이지. Modular amplifier rack system

INSTALLATION

MOUNTING

A fully loaded RM100 frame is heavy! To protect yourself and the equipment,

mount the empty RM100 enclosure securely before plugging in the power and

amplifier modules. The RM100 is designed for free vertical air convection

cooling. We recommend at least one rack unit (1-3/4 inches) spacing between

stacked units or forced air cooling of more densely stacked frames. If using

forced air, seal frames and joints between frames with duct tape and use blank

panels to seal any empty slots to avoid losing air pressure.

WIRING

The RM100 is supplied with mating connectors for the PS100 power supplies

mounted on the right side of the enclosure and with all power busing in place,

ready to plug on to the mating amplifier connector assemblies. Install amplifier

modules starting at the most left hand position (opposite from power supplies)

and stack side-by-side for optimum shielding of each module.

The connector assemblies supplied with each amplifier module mount on the rear

of the rack frame using supplied metric hardware: (4) M 2.5 x 6 mm screws.

System audio inputs and outputs connect to a 15-position barrier block using a

supplied mating fanning strip for easy pre-wiring. The 15-position fanning strip

may be cut into smaller sections if desired; e.g., inputs only, outputs only. The

fanning strip is Kulka P/N 649A15 and replacements are available from ATI

stock. Wire the audio inputs and outputs using the connector assembly markings

as a guide. NOTE: Barrier block screws are tightly machine inserted by the

manufacturer. Protect your knuckles by loosening them a few turns before

mounting them in a rack where they are hard to reach. Doing so will make it

much easier to install your pre-wired fanning strips at 3 AM. Fanning strips fit

onto barrier blocks from the left.

On special order, connector assemblies with .025 posts instead of the barrier

block are available. These posts mate with AMP MTA100 Series plug-on

connectors. The MTA connectors are solderless insulation displacement types.

Special tools for wire insertion into the MTA connectors include a simple and

inexpensive maintenance type tool, AMP 59803-1, and a precision ratchet type

self-indexing hand tool, AMP59801-1. Consult factory for more information.

ATI Audio Inc.

■ Tel: 856-626-3480

■

Fax: 856-504-0220

■

www.

audio.com