Andersen 400 Series 조정 - 페이지 2

{카테고리_이름} Andersen 400 Series에 대한 조정을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen 400 Series 4 페이지. Lock mechanism
Andersen 400 Series에 대해서도 마찬가지입니다: 설치 및 제거 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (6 페이지), 변경 매뉴얼 (2 페이지)

페이지 인쇄

NOTICE

• Hinge replacement WILL NOT correct problems

resulting from improper door installation

Examples of improper installation include units

not being installed plumb, level, and square,

excessively bowed jambs, and/or crowned sills.

Hinge Replacement

Door Panel

Remove screws from hinge using a phillips screwdriver. Dispose of hinge and screws properly.

Door Panel

Frame

Apply replacement hinge and fasten to frame using two (2) #10 x 1" screws through top and

bottom holes and two (2) #10 x 3" screws through center holes.

▶ Hinge replacement is complete.

▶ Proceed to hinge and hardware adjustment, below, for operation check and hinge adjustment instructions.

0 0 05 41 3

Remove and replace only one

hinge at a time. Removal of more

than one hinge may result in door

panel falling and potentially

causing personal injury, product,

and/or property damage.

Frame

#10 x 1"

Screws

(top and

bottom holes)

Door Panel

• Make all horizontal adjustments first. Horizontal adjustments correct

most problems. Vertical adjustments are rarely needed.

• Adjust hinges with door slightly open. The door panel should be

supported by all hinges for maximum hinge performance.

• Start adjustments at bottom hinge and move upward.

WARNING

#10 x 3"

Screws

(center holes)

Frame

IMPORTANT

#10 x 1-3/4"

Screws

Door Panel

Fasten hinge to door panel using four (4)

#10 x 1-3/4" screws. Repeat steps 1-3

for all hinges being replaced.

Frame