Andersen A1 설치 매뉴얼 - 페이지 3
{카테고리_이름} Andersen A1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Andersen A1 14 페이지.
페이지 인쇄A N D E R S E N
A 1 I N S T A L L A T I O N G U I D E
C H E C K T H E P A R T S
1
Check the supplied carton(s). See
exploded view of packing, fig F1.1
If there is any significant visible damage
to the main carton, A then photograph
the damage and sign for the carton as
damaged before opening. Report the
damage to the sender.
2
Place the main carton, A on a stable firm
surface the correct way up and open the
top. Take care not to cut items in the carton.
3
Remove the smaller carton, B from the
top of the main carton, open and check
that the correct decorative front panel,
1-0 is present and undamaged.
NOTE: There are two available types of panel,
Metal, 1-1 OR Wood 1-2, only one panel is
supplied per charger.
Place decorative front panel back in its
carton for later use.
4
Remove back panel, item
2-0, check it is undamaged and place to
the side for later use.
5
Remove the control unit, 3-0, check that
it is the correct model and colours and
is undamaged, take care and do NOT
remove any of the protective films, replace
back in the main carton for later use.
6
Remove the accessory pack 4-0 and
check it contains: -
4-1 4 x decorative front panel
retention screws.
4-2 4 x back panel spacer washers.
4-3 2 x charger retention
tamperproof screws.
Place to one side for later use.
Fig F1.1
3-0
A
A N D E R S E N
1-1
B
2-0
A
PAGE 3