Community Distributed Design DS8SUB 설치 및 운영 매뉴얼 - 페이지 6
{카테고리_이름} Community Distributed Design DS8SUB에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community Distributed Design DS8SUB 12 페이지. Distributed design series surface mount loudspeakers
Community Distributed Design DS8SUB에 대해서도 마찬가지입니다: 설치 및 운영 유지보수 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Infin-A-Ball™ Mounting System
Community's Infin-A-Ball™ (IAB) mounting
system allows low-profile mounting and precise
aiming over a broad tilt–swivel range. The IAB
ball-mount receptacle is factory pre-attached to
a recess in the cabinet, and after placing the
loudspeaker onto the IAB bracket, you need
only to twist the included hex wrench to lock any
position. The IAB bracket has factory-installed
internal wiring with an internal 4-pole Euroblock
connector in its base (for neat loop-through
connections) and a 2-pole male Euroblock plug
near the ball end for connection to the cabinet.
An IP56 wiring cover is also pre-installed,
providing snap-on weather-resistant protection.
Actual clamping screw
pressed against ball end
of IAB bracket.
Distributed Design Series
Surface Mount Loudspeakers
Loosen clamp using provided hex wrench,
rotate loudspeaker cabinet to desired position,
Installation and Operation Manual
then tighten clamp to lock
Page 6