Community Distributed Design DS8SUB 설치 및 운영 매뉴얼 - 페이지 7
{카테고리_이름} Community Distributed Design DS8SUB에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Community Distributed Design DS8SUB 12 페이지. Distributed design series surface mount loudspeakers
Community Distributed Design DS8SUB에 대해서도 마찬가지입니다: 설치 및 운영 유지보수 소유자 매뉴얼 (12 페이지)
페이지 인쇄
Installation and Wiring
1. Connect incoming input wires (and
optional loop-thru wires) from wall
to 4-pole Euroblock screw terminals
concealed in the base of the Infin-A-Ball
bracket.*
*Note: Check local codes
to determine if a wall box
or metal plate is required
for the integrated wiring.
See page 10.
2. Secure the Infin-A-Ball bracket to the wall
using your screws or other fasteners according
to local building and safety codes.
3. Insert the hex wrench into the socket near
the rear of the loudspeaker cabinet, and turn
counterclockwise to loosen the clamp setscrew.
4. Fit the cabinet onto the IAB bracket's ball-
end, then tighten the clamp sufficiently to
hold the loudspeaker in place, but allowing for
positional adjustment.
Distributed Design Series
Surface Mount Loudspeakers
Input Wires
(not included)
Loop-Thru Wires
(optional)
Infin-A-Ball bracket
Installation and Operation Manual
Terminal Block
Loosen
Tighten
Page 7