Drehmo i-matic 사용 설명서 - 페이지 6
{카테고리_이름} Drehmo i-matic에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Drehmo i-matic 20 페이지. Electrical actuator with integral controls
Drehmo i-matic에 대해서도 마찬가지입니다: 설치 및 운영 매뉴얼 (18 페이지)
페이지 인쇄- 1. Connection on Matic C Base Plate DMC - 02 (Since Hw Rev. 5)
- 2. Connection on I-Matic Interface Unit DIM - 09 (Devicenet)
- 3. Connection on Matic C Display Unit DMC - 30 (Lcd Display Unit)
- 4. Connection on I-Matic Display Unit DIM - 02 (Ir / Irii)
- 5. Connection on I-Matic Interface Unit DIM - 17 (Modbus Loop)
2 Driver installation
2.1 Driver installation under Windows XP
The usage of the adaptors by means of a PC with operating system Windows XP requires
the installation of DREHMO specific drivers. These drivers can be downloaded from the
companys web site www.drehmo.com.
This chapter shows the user of the adaptor kit how the installation procedure of the required
drivers are done under the operation system Windows XP
The device simulates a virtual communication port under Windows over which the device is
accessed by the service tools. To install the needed drivers please follow the instructions in
the respective section below.
System requirements
Software:
Windows XP SP2
Hardware (recommended):
Min. 700MHz CPU
Min. 128MB RAM
Download the latest available drivers from the Drehmo website
them to a location on your PC.
If you are running Windows XP or Windows XP SP1, temporarily disconnect your PC from
the Internet. This can be done by either removing the network cable from your PC or by
disabling your network card by going to the "Control Panel\Network and Dial-Up
Connections", right clicking on the appropriate connection and selecting "Disable" from the
menu. The connection can be re-enabled after the installation is complete. This is not
necessary under Windows XP SP2 if configured to ask before connecting to Windows
Update. Windows XP SP2 can have the settings for Windows Update changed through
"Control Panel\System" then select the "Hardware" tab and click "Windows Update".
Connect the device to a spare USB port on your PC. This will launch the Windows "Found
New Hardware Wizard". If there is no Internet connection available or Windows XP SP2 is
configured to ask before connecting to Windows Update, the screen below is shown. Select
"No, not this time" from the options available and then click "Next" to proceed with the
installation. If there is an Internet connection available, Windows XP will silently connect to
the Windows Update website and install any suitable driver it finds for the device in
preference to the driver manually selected.
DREHMO
Instruction manual for USB adaptor kit
www.drehmo.com
page 6 of 20
and unzip