Dremel 3D20 Idea Builder 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} Dremel 3D20 Idea Builder에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dremel 3D20 Idea Builder 4 페이지. Unclogging
Dremel 3D20 Idea Builder에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (4 페이지), 빠른 시작 매뉴얼 (2 페이지), 문제 해결 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Step 2: Disconnect all electrical wires from

the extruder

1. Disconnect all four wires from the extruder, as pictured.

Always be sure to pull the connectors by the plastic, and

never by the wires. Pulling by the wires can damage the

connectors.

Step 3: Remove the front fan and extruder

motor

1. Unscrew the two screws in front of the extruder fan using

the 2.5mm hex wrench.

2. Remove the front fan and heat sink, ensuring that the parts

attached to the screws do not fall. These parts can be

removed from the extruder as an assembly.

3. Remove the motor from the back of the extruder.

Step 4: Remove the turbo fan from the side of

the extruder

1. Remove the screw on the bottom left corner of the

extruder, as shown below. Removing this screw also

removes the fan baffle from the extruder.

2. Remove the back left screw from the extruder.

3. Pull the turbo fan away from the mounting carriage.