Dremel 3D20 Idea Builder Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Printer 3D Dremel 3D20 Idea Builder. Dremel 3D20 Idea Builder 4 halaman. Unclogging
Juga untuk Dremel 3D20 Idea Builder: Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (8 halaman), Panduan Memulai Cepat (4 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pemecahan Masalah (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman)

Step 2: Disconnect all electrical wires from

the extruder

1. Disconnect all four wires from the extruder, as pictured.

Always be sure to pull the connectors by the plastic, and

never by the wires. Pulling by the wires can damage the

connectors.

Step 3: Remove the front fan and extruder

motor

1. Unscrew the two screws in front of the extruder fan using

the 2.5mm hex wrench.

2. Remove the front fan and heat sink, ensuring that the parts

attached to the screws do not fall. These parts can be

removed from the extruder as an assembly.

3. Remove the motor from the back of the extruder.

Step 4: Remove the turbo fan from the side of

the extruder

1. Remove the screw on the bottom left corner of the

extruder, as shown below. Removing this screw also

removes the fan baffle from the extruder.

2. Remove the back left screw from the extruder.

3. Pull the turbo fan away from the mounting carriage.