Compac WD500 G1 운영 매뉴얼 - 페이지 14

{카테고리_이름} Compac WD500 G1에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Compac WD500 G1 15 페이지. Wheel dolly

Mount cylinder E.

Remove transport plug A and mount the

plug with vent B.

(EN)

5374 WD500 G1 (EN).docx

Remove the screw and washer on the cylinder.

Place the cylinder in the chassis bracket.

Mount the screw and washer as shown.

Gently tighten the screw by hand; it is tightened

mechanically after the mandrel at the top is

mounted.

Remove the retaining ring at the top and pull out

the mandrel.

Place the cylinder's ram in the tower and push

the mandrel through the fitting.

Mount the retaining ring again.

Note: Now tighten the screw on the cylinder

using a 19 mm wrench.

Remove the cable ties locking the tower.

Oil plug B comes fastened in the illustrated fixture.

14 / 15

Knowhow is the difference

2020-01-24 R1.1 S1