Alert 450R 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Alert 450R에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alert 450R 14 페이지. Remote starter system
REMOTE START OPERATION
2. Before turning off the engine, press and release the
at the same time.
-- The parking lights will turn on to indicate the remote starter has entered
turbo cool down mode. --
3. Turn off the Ignition Key and remove the key from the ignition switch.
-- The engine should remain running. --
4. Exit and secure the vehicle.
-- The engine will continue running until the pre-programmed time has
elapsed.
G. TIMER START:
This unit can be programmed to start and run the engine every 2 or 3
hours. The engine will run for the programmed run time and then shut
down.
IMPORTANT: Timer Start should be used only in open areas, never
start and run the vehicle in on enclosed space such as a garage or carport.
2 or 3 hour timer start: This feature is design for an extreme cold climate
usage. The system will auto start the vehicle every 2 or 3 hours, to prevent
engine from freezing or a hard starting engine. A MAXIMUM OF SIX
CYCLES CAN OCCUR.
ENTER:
1. Press the
vehicle is running, the parking lights will turn on.
2. Immediately depress the
3. Rapidly depress the
siren or horn will chirp (3) times. The vehicle is now programmed to
start every 2 or 3 hours.
4. Press the brake pedal to shut the engine off.
Exiting the timer start:
Timer start can be exited manually as follows:
1. Make sure the vehicle is not in remote start mode.
2. Turn the ignition key ON. The LED and parking lights will flash (4)
times. The siren or horn will chirp (4) times. Or you can:
Press the
button twice to remote start the vehicle. As soon as the engine
is running and the parking lights have turned on or are in flashing mode.
1. Immediately depress the
for 2. seconds. The parking lights will flash (4) times. The siren or horn
will chirp (4) times. The unit is no longer programmed to start
automatically.
button twice to remote start the vehicle. As soon as the
button. The parking light will flash (3) times. The
button once, within 2 seconds
button, then press and hold the
and
buttons
button
.
11