Alert 450R 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Alert 450R에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alert 450R 14 페이지. Remote starter system

REMOTE START OPERATION

SAFE START (Child safety mode) (See Start Feature 1 5 Programming.)

Factory default settings to press the

remote start the vehicle. Programming this feature to eliminate an accidental

remote starts.

This requires the user to press the transmitters

same time to remote start the vehicle.

B. ENGINE START PROGRAMMING FOR VEHICLES WITH MANUAL

TRANSMISSIONS (Cut the VIOLET LOOP wire for a manual transmission

vehicles)

The control module senses the neutral safety switch position on a automatic

transmission vehicle and no prior set-up required. The system for the manual

transmission vehicles follows this process when you exit the vehicle to sense

and memorize the neutral safety switch position. If the vehicle has a automatic

transmission, this process is omitted.

1. While the engine is running with the ignition key, set the emergency

brake and place the manual transmission in the neutral position.

2. Before turning off the engine, press the

-- The LED indicator will flash 3 times to confirm it has been entered.

3. Turn off the Ignition Key and remove it from the ignition switch.

--The engine should continue running until the pre-programmed time has

elapsed or the shutdown input is received.--

4. Exit the vehicle and close all doors.

-- The engine should still continue running and this is a normal operating

procedure.--

5. Within 1 minute from the time of step 1, press the

transmitter to lock the doors.

6-1. If the engine shuts down immediately, the system is now ready for

remote engine starts.

6-2. If the engine does not shut down immediately, the system has failed.

Repeat the above process again.

If a door is opened after the above procedure, the prior memorization for

the next remote or programmed engine start sequence is deleted and the

remote start function will not work until you repeat the above process again.

Note: If the remote start programming is set up, the dome light supervision

function will be temporarily

By-passed.

button twice on the transmitter to

and

button twice on the transmitter.

buttons at the

button on the