Atlas Copco PB 14 D 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Atlas Copco PB 14 D에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PB 14 D 11 페이지.
페이지 인쇄
1
Dismantling the
Remove the catcher housing (8), the
anvil assembly
rubber ring (7), and the recoil absorber (6)
from the anvil housing (2).
2
Expel the anvil (4) together with the recoil
ring (5) from the housing (2) by hitting it
lightly with a hammer.
3
Remove the location ring (10) and the
O–rings (11 and 12) from the hammer
case (13).
4
Remove the O–ring (9) from the anvil
housing (2), place this upon a press table,
and press the liner (1) from the housing
using a mandrel.
Only remove the liner if it is damaged or
badly worn. Only let authorized personnel
with proper tools remove the liner.
1
Removing the
Remove the six Allen screws (1) together
hammer case
with the washers.
2
Remove the hammer case (2) from the
bearing housing (3).
Attention! Make sure you lose no parts that
might fall from the machine!
1
Removing the
Pull the complete inclined shaft bearing
inclined shaft
assembly (5) from the hammer case (1).
bearing
2
Remove the outer ring (6) from the
assembly
inclined shaft bearing assembly.
3
Remove the outer ring (4), the washer (3),
as well as the eight disc springs (2) from
the hammer case (1).
In case that the outer ring is stuck in the
hammer case, unscrew and remove the
edn cap (7) and press the ring out from
this side.
Repair instruction No. 171.5/94
PB 14 D, PB 14 C
3 4
1
2
1
7
5
6
7
10
11
13
8 9
12
1
2
3
2
3
4
5
6
PAGE
2