Atlas Copco PB 14 D 빠른 시작 매뉴얼 - 페이지 3

{카테고리_이름} Atlas Copco PB 14 D에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Atlas Copco PB 14 D 11 페이지.

Dismantling the

Press the complete inclined shaft bearing

inclined shaft

assembly (3) from the taper roller bearing

bearing

(1) and the gear (2).

assembly

Turn the inclined shaft bearing assembly

over and press the taper roller bearing (4)

and the layshaft (6) from the inclined shaft

bearing with the service tool (7)

(9170 3023 30), as shown in illustration.

Removing and

Remove the piston (4) from the hammer

dismantling the

case (1). If necessary, hit the case lightly

piston

with a plastic hammer.

First remove the bearing clip (5) from the

piston, then take out the gudgeon pin (3).

Remove the nu–lip–seal (2) with a

screwdriver.

Removing the

Loosen the striker (1) by hitting the

striker

hammer case (4) lightly with a plastic

hammer and remove it.

Remove the nu–lip–seal (3) as well as the

two striker bearing clips (2) from the

striker.

Removing the

The barrel (2) should only be removed if

damaged or badly worn.

barrel

Release the three screws (4) from the

barrel retainer (3) and remove it.

Press the barrel (2) from the hammer

case (1).

Repair instruction No. 171.5/94

PB 14 D, PB 14 C

2 3 4

PAGE