Bose Acoustimass 6 Series III 소유자 매뉴얼 - 페이지 13

{카테고리_이름} Bose Acoustimass 6 Series III에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bose Acoustimass 6 Series III 23 페이지. Home theater speaker sytem
Bose Acoustimass 6 Series III에 대해서도 마찬가지입니다: 소유자 매뉴얼 (18 페이지), 빠른 설정 매뉴얼 (1 페이지), 소유자 매뉴얼 (44 페이지), 소유자 매뉴얼 (16 페이지), 소유자 매뉴얼 (25 페이지)

페이지 인쇄

For realistic home theater sound

CAUTION: The Acoustimass@

and Acoustimass

speaker systems incorporate an auto-

matic protection circuit, which guards against most kinds of damage from electrical stress or

overload. Thi8 circuit activates at high volume levels to reduce output, causing

81ight

decrease in volume. This is normal operation and indicates that power input may be exceed-

ing safe levels. Sustained listening at these levels is not recommended.

Adjusting the LFE level

(low frequency effects)

The

LfE

level control on your powered Acoustimass module increases or decreases the rela-

tive level of low frequency effects on movie soundtracks. Use it to regulate the presence of

these underlying deep bass sounds. Use the "test tones" feature in your digital surround

sound receiver to match the volume levels for each of the cube speakers. Then use the

LfE

control on the Acoustimass module to match the volume of the LFE channel to the cube

speaker channels.

Adjusting the bass/room compensation level

This feature will allow you to fine-tune your system after you have placed the Acoustimass

module in your selected location. If the room sounds "thin" or lacks bass, turn the BASS con-

trol in a clockwise direction to increase the bass level of the module.

the room sounds

"boomy" or has too much bass, turn the knob in a counter-clockwise rotation to reduce the

bass level of the module. The factory or detent setting is appropriate for a majority of listening

situations.

Setting your digital surround sound receiver

Your Acoustimass 6 or Acoustimass 10 speakers are compatible with the output from digital

surround receivers. Integrated Signal Processing assures full bass reproduction for all chan-

nels regardless of receiver settings. However, the following table suggests a set of recom-

mended receiver settings. The cube speaker arrays should be set to

lARGE

in the receiver's

digital display menu. The

lfE,

or subwoofer, is set to ON. If applicable, the crossover value

should be set to the lowest number possible, typically 80 Hz.

Front left and right

Front center

Rear left and right

LFEISubwoofer

LARGE