Anolis ArcPower 144 사용자 설명서 - 페이지 6

{카테고리_이름} Anolis ArcPower 144에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Anolis ArcPower 144 20 페이지.

페이지 인쇄

1. DMX Operating

This device falls under protection class I.Therefore the ArcPower 144 has to be connected

to a mains socket outlet with a protective earthing connection.

4.2.Mounting the ArcPower 144

Flat surface

The ArcPower 144 should be be placed on a non-f lammable f lat surface in any orientation and fixed by the

four screws.There are 4 mounting holes of 5x7 mm in housing of the driver.

4.3 Conection cables

1. The adapter cable RJ45/XLR connects the ArcPower 144 to the DMX controller. If your DMX controller has

RJ45 socket for DMX output, use RJ45 patch cable for connection with the ArcPower 144.

RJ45 plug

View facing pins

Pin 1: Not used

Pin 2: Not used

Pin 3: Not used

Pin 4: Not used

Pin 5: +5V

Pin 6: Data +

Pin 7: Data -

Pin 8: GND

2. RJ45 patch cables category 5 that connect the ArcPower 144 each other are wired 1:1,

that is, pins with the same numbers are connected together.

Pin 1: Not used

Pin 2: Not used

Pin 3: Not used

Pin 4: Not used

Pin 5: +5V

Pin 6: Data +

Pin 7: Data -

Pin 8: GND

Screws

DMX 512 XLR plug (male)

Front view of the plug

Pin 1: GND

Pin 2: Data -

Pin 3: Data +

Pin 4: Not used

Pin 5: Not used

Pin 1: Not used

Pin 2: Not used

Pin 3: Not used

Pin 4: Not used

Pin 5: +5V

Pin 6: Data +

Pin 7: Data -

Pin 8: GND

Screws

Mounting holes