Daintree GE current Lumination LPL Gen D Series 설치 매뉴얼 - 페이지 3

{카테고리_이름} Daintree GE current Lumination LPL Gen D Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daintree GE current Lumination LPL Gen D Series 4 페이지. Led luminaire

페이지 인쇄

Lumination

LPL Gen D Series

Electrical Connections - Basic version

Electrical enclosure cover

Optional Installation: 0-10V Volt Dimming

Remove electrical enclosure cover with three Knock-Outs on the top. Carefully remove knockout for AC mains input wires. Install

UL listed electrical fittings in the knockout holes for wire protection.

Connect the AC mains to the black (line) and white (neutral) input wires of the fixture by using UL listed connectors or wire-nuts

for 14-18 AWG.

Connect the ground wire to the green-yellow ground wire of luminaire. When connecting dimming controller, wires must run

through a separate knockout hole equipped with an appropriate wire restraint or cable gland. Then, re-attach and fix electrical

enclosure cover with screw by screwdriver.

Option: Follow diagram for 0-10V. Run wires from controller through a different knockout than the AC input wire. At the output

side of fixture, make appropriate connections by using UL listed connectors or wire -nuts. To combine with LFAMBA0VQFAEL,

LCAMBA0NRFAEL, LCAMBA0TSFAEL, LCAMBA0TQFAEL, LFAMBADVQFA, LCAMBA0NRFAB2,LCAMBA0TSFAB2, LCAMBA0TQFAB2,

LCAMBA0NRFA, LCAMBA0TSFA or LCAMBA0TQFA, please follow the installinstructions provided with those products.

NOTE: Please cover dimming leads with wire nuts if leads not be connected.

Line

Black

Neutral

White

Ground

Green/Yellow

1-10V(+)

Violet

1-10V(-)

Pink

Installation Guide

Dimming

AC mains

AC Mains

To 0-10V

Dimmer