Daintree GE current Lumination LPL Gen D Series 설치 매뉴얼 - 페이지 4

{카테고리_이름} Daintree GE current Lumination LPL Gen D Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Daintree GE current Lumination LPL Gen D Series 4 페이지. Led luminaire

페이지 인쇄

Lumination

LPL Gen D Series

Electrical Connections - Sensor version

Sensor enclosure cover

Remove sensor enclosure cover. Carefullyremove knockout for AC mains input wires. Install UL listed electrical fttings in

the knockout holes for wire protection.

LPL22x

Connect the AC mains to the black (line) and white (neutral) input wires of the LED driver by using UL listed connectors or wire-nuts

for 18-14 AWG.

LPL24x

Connect the AC mains to the brown (line) and blue (neutral) input wires of the LED driver by using UL listed connectors or wire-nuts

for 18-14 AWG.

Connect the ground wire to the green-yellow ground wire of luminaire. When connecting dimming controller, wires must run

through a separate knockout hole equipped with an appropriate wire restraint or cable gland. Then, re-attach and fix enclosure cover

with screw by screw driver.

Line

Black (or Brown)

Neutral

White (or Blue)

Ground

Green/Yellow

www.gecurrent.com

General Electric Company and are used under license. Information provided is subject to change without

notice. All values are design or typical values when measured under laboratory conditions.

IND676

REV-A

AC mains

AC Mains

Installation Guide