DSC PC5100 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} DSC PC5100에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSC PC5100 12 페이지. 2-wire addressable device interface module

Getting Started

2.1 Connecting the PC5100 Interface Module

Remove all power from the control panel before connecting

any module to the system.

Connect the PC5100 to the PC5010/5015 Keybus by inserting the red,

black, yellow and green Keybus wires into their corresponding termi-

nals.

If the PC5100 is not located within the main cabinet, a PC5204

power supply must be used to power the module, as in the

diagram below.

After wiring is complete, add power back to the PC5010/PC5015.

The system will detect the new module and it will be supervised.

2.2 Calculating Current Draw

Up to 32 addressable devices can be connected to the PC5100.

However, a maximum of 170mA of current can be used on the address-

able loop. Calculate how much current your selection of devices will

require by completing the following table: