3M Litmann Quality 3100 사용 설명서 - 페이지 9
{카테고리_이름} 3M Litmann Quality 3100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M Litmann Quality 3100 16 페이지. Mining cable splice kit
3M Litmann Quality 3100에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
6.7
If present, fold back grounds and ground check conductors and temporarily tape
to cable jacket with vinyl tape.
6.8
Select one conductor and cut conductor approximately 9" (230 mm). Match this
conductor with same color conductor on opposite end.
6.9
Rotate cable so conductor twist will match original cable lay as much as
possible.
6.10
Take next conductor in rotation and cut approximately 6" (150 mm) from end.
6.11
If present, remove color code and/or separator tape for length of phase.
6.12
Remove insulation from ends of conductors for one-half connector length if
using butt splices, or two connector lengths if using parallel splices.
6.13
Pencil insulation for approximately ½" (13 mm), sand smooth and clean with
solvent wipe.
78-8127-6830-3-C
Fold back grounds &
ground check conductors
Figure 18
9"
(230 mm)
6"
(150 mm)
Figure 19
9
12"
(305 mm)
½"
(13 mm)
Required connector length