ansio 1308 지침 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} ansio 1308에 대한 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ansio 1308 10 페이지. Portable ptc ceramic heater

COMPONENTS OF THE HEATER

Power Light

Temperature

Control Knob

BEFORE USING THE HEATER

1. Check if the power cord is in good condition.

2. Ensure that the heater is connected to an appropriate power socket in accordance

with the local regulations.

3. Always place the heater on a flat surface. The tip over switch at the base of the

heater will turn the heater OFF if the heater is placed on an uneven/soft surface such

as carpet or if the heater is accidentally knocked off.

1. Insert the plug into the power socket.

2. Turn the Power selection knob clockwise to choose between one of the following

modes:

Fan only mode:

The fan in the heater is intended to assist with the circulation of hot

air and is not for the purpose of cooling the room.

Low Power Mode:

The heater operates at 1200 W.

High Power Mode:

The heater operates at 2000 W.

3. Turn the Temperature control knob clockwise to set the desired temperature.

Note: The temperature control knob acts as a thermostat. In the event of

overheating, the heater will be turned OFF automatically.

Customer Support - UK Toll Free 0800 080 6781 or +44 207 157 9795

ANSIO 1308 (M21v01)

Power Selection

Knob

Safety Grille