DSE DSE705 운영 매뉴얼 - 페이지 10

{카테고리_이름} DSE DSE705에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DSE DSE705 13 페이지. Ats control module

6 SPECIFICATION

Cranking Dropouts:

Alternator Input Range:

Mains Input Range

Alternator Input Frequency:

Mains Input Frequency

Auxiliary Outputs:

Operating Temperature Range:

Applicable Standards

Deep Sea Electronics plc reserve the right to change specification without notice.

- 10 -

057-043 705 Operating Instructions Issue 1.1 18/06/2007

705 ATS controller operators manual

DC Supply:

8 Volts to 35 Volts DC Continuous.

Able to survive 0 Volts for 50 mS, providing supply was at

least 10 V before dropout and supply recovers to 5 Volts.

This is achieved without the need for internal batteries.

Max. Current:

Operating 50mA

Standby 10mA

75 Volts (ph-N) to 277 Volts (ph-N) AC (+20%)

15 – 277 Volts (ph-N) AC (+20%)

50 - 60 Hz at rated engine speed

(Minimum: 75V AC Ph-N)

Generator available 45Hz

Generator failed 20Hz

50 – 60 Hz

Start Output:

1.2 Amp DC at supply voltage.

Fuel Output:

1.2 Amp DC at supply voltage.

Dimensions:

125mm x 165mm x 28 mm

Charge Fail:

12 Volts = 8 Volts CF 24 Volts = 16 Volts CF

-30°C to + 70

Compliant with BS EN 60950 Low Voltage Directive

Compliant with BS EN 50081-2: 1992 EMC Directive

Compliant with BS EN 61000-6-4: 2000 EMC Directive

Compliance to European Legislation

Registered Component for USA & Canada