Attero Tech unA4O AES67 사용자 설명서 - 페이지 10
{카테고리_이름} Attero Tech unA4O AES67에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Attero Tech unA4O AES67 11 페이지. Four output interface
3.3 – Factory Reset
*******************************************************************
IMPORTANT
*******************************************************************
The factory reset returns the entire device to its factory defaults.
Using this feature will mean all custom AES67 settings and all
audio power-on default settings will be cleared.
*******************************************************************
*NOTE: The factory reset is a useful way of quickly restoring
communications with a device which has an unknown static IP
address as a factory reset returns the device's network settings
to getting a dynamic IP. Having successfully completed a factory
reset of the device, setting the PC's IP address to also obtain a
dynamic IP address should then allow the PC to communicate fully
with that device.
The factory reset button is accessed through a small hole on the
front of the unit using a small screwdriver or a paperclip. A factory
reset is initiated by pressing and holding this button for 5
seconds or more while the device is running and then releasing
it. If done correctly, the status will change state as the unit goes
through a reset process. If the LED's remain green immediately
after releasing the button, that is an indication the button was not
held for long enough and the factory reset was not applied.
Having applied a successful factory reset, on the AES67 side,
customized device name and channel names will be cleared, the
transmit stream data cleared and disabled and any receiver
stream data will be removed. The network settings will also be
reset so the device will return to retrieving an IP address
dynamically. The power-up defaults for the audio settings are also
cleared. For every output, output volume is set to maximum (0dB)
and the output mute is disabled.
1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260) 496-9668 ⁞ www.atterotech.com
3.4 – Firmware Updates
The unA4O has the ability to be updated. Updates are applied
via the network using Attero Tech unIFY Control Panel's Smart
Firmware update facility. The latest unA4O SFU file is available
from the Attero Tech customer portal.
3.5 – 3rd Party Control
The unA4O supports 3
party control allowing external system to
rd
manage the unA4O's settings such as phantom power, mic/line
gain options and control of presets. The interface which is
available to anyone to use with any device capable of sending and
receiving UDP messages.
Information on the commands the unA4O supports as well as
details of how to use the 3
rd
the unIFY 3
party Software API document, available from the
rd
registered users section of the Attero Tech website (Go
to
www.atterotech.com
and click on the log-in option).
party UDP interface can be found in
Page 10