DT DT SCREENS Dynamic 2S 설치 매뉴얼 - 페이지 4

{카테고리_이름} DT DT SCREENS Dynamic 2S에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DT DT SCREENS Dynamic 2S 12 페이지.

Unpacking

Each screen is carefully packaged in our factory to ensure that it reaches you in perfect condition.

Each section is wrapped in protective packaging or in a PVC sleeve to ensure it is protected and stays

clean.

Do not unpack each piece from its protective packaging until you are ready to install it. This

will ensure that you do not damage any of the velvet finished pieces accidentally during installation.

Note that the Dynamic 2s is designed to be assembled on the wall so that a clear floor area big

enough to build the screen is not required. However, it can also be built on the floor if preferred you

will just need to follow the same instructions but substitute the wall for the floor then lift and attach

the screen to the wall once built. DO NOT built the screen face down on the floor under any

circumstances as this will result damage to the screen and mechanism.

The screen is a 6-part frame. 2 end sections (containing the masking), 2 top sections and two bottom

sections. The bottom right section also houses the control box for the screen.

Frame Section Configuration Fig. 1

Dynamic 2S Installation Manual – V0.2