anytronics Anyscene 512 설치 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} anytronics Anyscene 512에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. anytronics Anyscene 512 13 페이지. Scene recall unit

8. External Scene Control

The Anyscene 512 also has the ability to use external isolated closing contacts to cycle

round memories 1-7 in ascending sequence. The contacts should be connected to the

two screw terminals on the back of the Anyscene 512 PCB, and the EXT DIL switch should

be set to ON.

When the Anyscene 512 is in DMX output mode (and not when in auto cycle mode), the

next scene from the 1-7 scene cycle will be selected on each contact closure. To facilitate

'debouncing' of contact closure, contact closing inputs which occur less than two seconds

after the previous contact closure will be ignored.

As with the auto cycle mode, if the power is disconnected during this step cycling, when

the power is restored the cycle will be restarted from whichever scene was first in the cycle.

Whilst in step cycle mode, whichever scene is active, it can be overridden by pressing one

of the scene recall buttons. The next contact closure will cause the Anyscene 512 to step

on to the next scene after this manually recalled scene. The remote contacts can be

disabled by switching the EXT DIL switch to OFF.

When in auto cycle or standby/receive modes, all contact closures are ignored.

Units 5 & 6 Hillside Industrial Estate

London Road, Horndean,

Hampshire, PO8 0BL

Tel +44 (0)23 9259 9410

Fax +44(0)23 9259 8723

Page 11 of 13

AT1039 Issue 1

Anyscene 512 Operating

Instructions