ABTronic PTZ-715WP 사용자 설명서 - 페이지 2
{카테고리_이름} ABTronic PTZ-715WP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. ABTronic PTZ-715WP 7 페이지. Outdoor ptz camera
1. Camera connections
Camera has three cables outside:
1) RS-485 communication:
violet (red): RS485 +
●
gray (black): RS485 -
●
2) Video signal
BNC socket: video composite signal
●
3) Power supply
2.1/5.5mm socket: DC12V / 800mA
●
2. RS-485 port configuration
The PTZ camera functions are controlled by RS-485 port. The port parameters can be set
using DIP-Switches or via RS-485 interface.
To set the switches positions, you have to remove the camera dome cover (unscrew 4
screws), and next remove the plastic protection (4 screws).
2.1 DIP-switches configuration
Device address setting:
The device address can be set in range: 1 – 63 (for PELCO-P: 0 – 63).
To enter the proper address you should use the DIP1 – 6 switches and set the right combination
according to below picture. The device address is the sum of the numbers from corresponding
switches, which were set to ON position.
The ON/OFF switches and corresponding numbers: