ABTronic PTZ-715WP Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan ABTronic PTZ-715WP. ABTronic PTZ-715WP 7 halaman. Outdoor ptz camera

1. Camera connections

Camera has three cables outside:
1) RS-485 communication:
violet (red): RS485 +
gray (black): RS485 -
2) Video signal
BNC socket: video composite signal
3) Power supply
2.1/5.5mm socket: DC12V / 800mA

2. RS-485 port configuration

The PTZ camera functions are controlled by RS-485 port. The port parameters can be set
using DIP-Switches or via RS-485 interface.
To set the switches positions, you have to remove the camera dome cover (unscrew 4
screws), and next remove the plastic protection (4 screws).

2.1 DIP-switches configuration

Device address setting:
The device address can be set in range: 1 – 63 (for PELCO-P: 0 – 63).
To enter the proper address you should use the DIP1 – 6 switches and set the right combination
according to below picture. The device address is the sum of the numbers from corresponding
switches, which were set to ON position.
The ON/OFF switches and corresponding numbers: