Danby DDW1801MWP 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Danby DDW1801MWP에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danby DDW1801MWP 11 페이지.

페이지 인쇄

WATER

CONNECTION

(cont)

INSTALLATION INSTRUCTIONS

1. Screw the faucet adapter onto (or into) the faucet tap. Check for

leaks (use Teflon tape to eliminate if necessary).

2. Connect the six-sided connection of the drain hose to the drain

port connection on the back of the dishwasher cabinet. Do not

over-tighten (to avoid damage to threads).

3. Connect the star-shaped connection of the inlet hose to the inlet

port on the back of the dishwasher cabinet. Do not over-tighten

(to avoid damage to threads).

4. Connect the circular connection of the drain hose onto the longer

(bottom) male connection on the quick connect.

5. Connect the circular connection of the inlet hose onto the shorter

(top) male connection on the quick connect.

6. Attach the quick connect onto the faucet adapter, by pulling down

the outer locking collar on the quick connect, while pushing the

quick connect upward onto the faucet adapter.

7. When the quick connect snaps onto the faucet adapter, release the

locking collar. Verify the connection is secure.

8. Slowly open the hot water line and check for any sign of water

leaks at all hose connections. If leaks are located, immediately

turn off the water supply and repair the hose connections.

1. Once you open the water supply line, (even if it is closed

immediately thereafter), the inlet hose will be pressurized.

2. To relieve water pressure from inside the inlet hose, (make

sure the water line (faucet) is closed): press and hold the

red pressure relief button on the quick connect until the

flow of water stops.

Failure to relieve water pressure before disconnecting the

quick connect from the faucet, will result in back pressure

over-spray. The temperature of the incoming water can be

very hot and can cause severe burns and/or scalding.

Do not let children disconnect the dishwasher. Close supervi-

sion of children is always important around appliances.

NOTE: Hard water conditions will adversely affect the washing

performance of your dishwasher. Hard water conditions will also

contribute to 'lime' (white film substance) deposits and/or 'scaling'

on the stainless steel surface of the dishwasher tub and heater ele-

ment, located in the sump underneath the removable filter screen.

To assist in minimizing these conditions, it is recommended to oper-

ate/rinse the inside of the dishwasher (empty) using 1 cup of white

vinegar once a week.

DISCONNECTING YOUR DISHWASHER

1. Shut off the water supply at the faucet.

2. Disconnect the power supply cord

3. Relieve water pressure

4. Pull down on the quick connect collar

IMPORTANT

WARNING

DANGER