Dancover COMMERCIAL TITAN Peak 240 8.82m2 매뉴얼 - 페이지 12

{카테고리_이름} Dancover COMMERCIAL TITAN Peak 240 8.82m2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dancover COMMERCIAL TITAN Peak 240 8.82m2 16 페이지.

Manual

GATE ASSEMBLY

STAGE 8

Installation of covering

Install honeycomb polycarbonate with a specified side facing outwards

(sunward); this side has a covering layer (make sure to clarify it on

buying or prior to installation). Covering layer is usually placed on the

side with notations on the shipping film. The film is transparent on the

opposite side of a sheet. After marking the sheet but prior to cutting

it, mark the side with the covering layer on each piece of the sheet:

when the shipping film is removed sheet sides look the same. Shipping

film shall be removed from the both sides immediately before fastening

covering on the frame.

Cut the sheets using a fret saw or a fine-pitch arm saw.

fig. 7.1

Arrangement of

angles for fastening

of polycarbonate on

the gate.

CUTTING LIST OF COVERING OF AN END

CUT POLYCARBONATE SHEET IN STRICT ADHERENCE TO FIG. 10.3

Honeycomb polycarbonate sheet size 2100 х 12000 MM

fig. 8.1

Cutting list of covering for an end of the

greenhouse 5.0 m wide.

140

1170

140

1330

remainder

2100