Airwalk 50CM PRO SLIDER 사용 설명서 - 페이지 3

{카테고리_이름} Airwalk 50CM PRO SLIDER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwalk 50CM PRO SLIDER 7 페이지.

3. Assemble The Handlebar To The Stem

Disc Brakes

If fitted with a front disc brake, the components should already be attached. However, please check all

connections before attempting to ride the bicycle. Secure tightly the 6 bolts that hold the disc to the wheel

hub (E) and the 2 bolts that hold the brake mechanism to the fork (F).

Insert the front wheel into the fork dropouts ensuring that the disc fits into the brake mechanism between the

enclosed brake pads. Secure the front wheel to the bicycle by tightening the bolts or quick release

mechanism depending on what your bicycle is equipped with.

The cable to the brake lever should already b attached, but please double check it is positioned correctly.

The cable should be in the cable end holder and then through the barrel adjuster and lock nut. Ensure that

the barrel adjuster and lock nut are rotated so the slots no longer line up. Ensure the cable housing seats

appropriately into the end of the barrel adjuster and check for any kinks or damage.

These brakes require breaking in!

Please be aware that the brake pads may slightly rub on the disc rotor, even after

adjustment. This is due to the fact that the brakes are required to be worn in.

Ride and use the brakes gently for at least 20km before using the brakes in downhill

conditions, for sudden stops or any other serious braking.

Please be aware that your brake system will change in performance throughout the

wear-in process. The disc brake should be cleaned before the first ride using

rubbing alcohol. NEVER use oil or similar products to clean your disc brake

system.

Disc Brake Adjustment

To adjust the distance between the pads and disc

1. Loosen the cable anchor bolt and hold the end of the cable.

Insert the handlebar (4) into the stem clamp and secure by

tightening the four Allen Bolts. Ensure the bolts are

tightened evenly.