Danfoss iC7 Series 설치 매뉴얼 - 페이지 6

{카테고리_이름} Danfoss iC7 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss iC7 Series 16 페이지. In-bottom/out-back cooling kit for fa09-fa10, frequency converters
Danfoss iC7 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (14 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (8 페이지), 설치 매뉴얼 (10 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (6 페이지), 설치 매뉴얼 (18 페이지)

In-back/Out-back Cooling Kit for FA09-FA10

Installation Guide

74 (2.9)

8x Ø 6 (0.2)

2x Ø 8 (0.3)

Mounting Holes

29 (1.1)

4x Ø 7 (0.3)

Illustration 4: FA10 Mounting Plate Template for In-back/Out-back Cooling

2.4 Preparing the Backplate

To create vent openings in the cabinet backplate to match the openings in the mounting plate, use the following steps. Refer to

Illustration 5

for FA09 frequency converters and

Procedure

Cut out the vent openings in the cabinet backplate using the dimensions in the FA09 or FA10 template.

The openings must match the mounting plate openings.

Drill screw holes (6 mm) around the vent openings.

The FA09 requires 6 holes around each vent opening, and the FA10 requires 8 holes around each. The holes must align

with the holes in the outer flanges of the ducts.

321 (12.6)

280 (11.0)

271 (10.7)

16 (0.6)

295 (11.6)

328 (12.9)

Illustration 6

for FA10 frequency converters.

2x Ø 8 (0.3)

Mounting Holes

110 (4.3)

130 (5.1)

10 (0.4)

1051 (41.4)

896 (32.3)

140 (5.5) 180 (7.1)

AN371942471353en-000101 / 136R0248

Installation