Danfoss VLT 2800 Series 빠른 시작 매뉴얼

{카테고리_이름} Danfoss VLT 2800 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss VLT 2800 Series 4 페이지.
Danfoss VLT 2800 Series에 대해서도 마찬가지입니다: 빠른 설정 (2 페이지), 설치 (2 페이지), 빠른 설정 (2 페이지)

페이지 인쇄

Assembly

■

■ Warnings

ESD Warning:

As the electronic components of the VLT

are susceptible to Electronic Discharge

- ESD - do NOT handle the VLT without

wearing a ground-connected wristband!

General Warning:

NB!:

It is important to note that the serial number

of the control card is placed on the back of the

front cover. This means that if several VLTs are or-

dered it is important to keep the right parts together

with reference to future ordering and warrenty .

Do not connect to mains

before the VLT is completely mounted

- this includes mounting of the front cover!

■ How to Assemble

The VLT 2800 consists of the following units:

Fig. 1: Power unit for VLT 2800

VLT

2800 Series

Fig. 2: Control card and front cover for VLT 2800

Before starting the assembly: Do not throw away

the ESD shielding bag in which the control card is

delivered as the bag will be needed for keeping the

control card if replaced!

1. Place the control card on the power unit. Make

sure that the right side of the control card is

placed under the taps of the power unit

2. Fasten the two screws on the left side of the con-

trol card. Use the enclosed torx screw driver for

this purpose

3. Connect the ﬂat cable from the power unit to the

control card. The plug is placed at the top left

corner

4. Place the front cover on top of the assembled

control card and power unit

5. Now it is important to initialize the VLT in order

for it to function correctly. Please follow the in-

structions below

NB!:

Manual initialisation is not possible on

the LCP 175N0131 control unit. It is, however,

possible to perform an initialisation via parameter

620 Operation Mode

Manual initialisation can be performed in two ways:

either

1. Cut mains

2. Press [QUICK MENU] + [+] + [CHANGE DATA]

and reconnect mains simultaneously

3. Release the keys

MI.28.A1.02 - VLT is a registered Danfoss trade mark