Danfoss FP735Si 설치 매뉴얼 - 페이지 15

{카테고리_이름} Danfoss FP735Si에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Danfoss FP735Si 20 페이지. Electronic 3-channel full programmer for heating and hot water with service interval timer
Danfoss FP735Si에 대해서도 마찬가지입니다: 빠른 매뉴얼 (4 페이지), 쉬운 사용자 설명서 (2 페이지)

페이지 인쇄

To perform a standard copy operation:

a) Press CH to select the channel.

b) Press PROG to go to event programming.

c) Press DAY/HOL to select the day to copy to.

d) Press COPY/i to copy the previous day's events to the displayed

day.

Advanced Copy

The Advanced Copy function is available in 7 day mode only. This

allows any day to be copied to any other day, or days.

To use the Advanced Copy function, go into the event programming

using the PROG button, then:

1) Press DAY/HOL to select the day to be copied from.

2) Press COPY/i to copy from the selected day.

When selected, the day will begin to fl ash.

3) Press DAY/HOL to select the day to be copied to.

4) Press COPY/i to copy to the selected day.

5) Repeat steps 3 and 4 to select and copy other days.

6) To stop copying, use the DAY/HOL button to go back to the

fl ashing day and press the COPY/i button. The previously

fl ashing day will stop fl ashing to indicate it has been de-selected.

NOTE: When a day has been copied to, it will remain visible and not

fl ashing when the DAY/HOL button is used to select other days.

Channel Copy

Channel Copy is used to copy events from one channel to another

channel.

To perform a Channel Copy operation:

a) Press CH to select the channel to copy to.

b) Press COPY/i to copy from the previous channel.

Danfoss Heating