AudioCodes Mediant 800C 빠른 설정 매뉴얼 - 페이지 5

{카테고리_이름} AudioCodes Mediant 800C에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AudioCodes Mediant 800C 10 페이지. Session border controller

Changing VMware Host's Network Settings

The default IP address of the VMware ESXi host on whose virtual machine the ZPLS module is running is

192.168.0.10/24. Instead of using this default address, you can change it (and other network settings) to suit

your IP addressing scheme.

To change VMware host's networking address:

Connect the RJ-45 connector on one end of a straight-through Ethernet cable (not supplied) to the

device's Gigabit Ethernet port #1 (located on the rear panel), and then connect the other end of the

cable to your computer (or laptop).

Change your computer's IP address (e.g., 192.168.0.100/24) so that it's in the same subnet as the

default address of the VMware host.

5 |

P a g e