Brainworx Ampeg SVT-VR 플러그인 매뉴얼 - 페이지 5

{카테고리_이름} Brainworx Ampeg SVT-VR에 대한 플러그인 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brainworx Ampeg SVT-VR 10 페이지.

페이지 인쇄

T h e A m p S e c t i o n

AMPLIFIER SECTION:

CHANNEL & NORMAL/BRIGHT SELECTION:

To select the SVT-VR channel you would like to

use, in either bright or normal mode, click on one of the four jacks. Use the two jacks

in the lower row to select either channel one or two in Normal mode and use the two

jacks in the upper row to select either channel one or two in Bright mode.

VOLUME (CHANNEL ONE):

Use this control to adjust the output level of channel one.

TREBLE (CHANNEL ONE):

Use this to adjust the high frequency level of channel one. This

provides up to 12 dB of boost, or 12 dB of cut at 4 kHz. The high frequency output is

flat at the center position.

MIDRANGE (CHANNEL ONE):

Use this to adjust the midrange frequency level of channel

one. This provides up to 20 dB of boost, or 20 dB of cut at the selected frequency.

BASS (CHANNEL ONE):

Use this to adjust the low frequency level of channel one. This

provides up to 12 dB of boost, or 12 dB of cut at 40 Hz. The low frequency output is

flat at the center position.

ULTRA-HI (CHANNEL ONE):

This switch, when engaged [right side down], enhances the

amount of high frequency output of channel one. The amount of boost is dependent

on the setting of the volume control.

Ampeg SVT-VR

1-2-3 (CHANNEL ONE):

midrange control. The available frequencies are 220 Hz (left side of the switch engaged),

800 Hz (switch in the center position), or 3 kHz (right side of the switch engaged).

BASS-CUT/OFF/ULTRA-LO (CHANNEL ONE):

the low frequency output of channel one. Engaging the right side of this switch enhances

the low frequency output of channel one. The switch is inactive in the center position.

VOLUME (CHANNEL TWO):

TREBLE (CHANNEL TWO):

provides up to 12 dB of boost, or 12 dB of cut at 4 kHz. The high frequency output is flat

at the center position.

BASS (CHANNEL TWO):

provides up to 12 dB of boost, or 12 dB of cut at 40 Hz. The low frequency output is

flat at the center position.

ULTRA-HI (CHANNEL TWO):

amount of high frequency output of channel two. The amount of boost is dependent

on the setting of the volume control.

ULTRA-LO (CHANNEL TWO):

low frequency output of channel two.

POWER SWITCH:

Use this switch to engage or bypass the plug-in.

This switch selects the frequency that will be affected by the

Engaging the left side of this switch decreases

Use this control to adjust the output level of channel two.

Use this to adjust the high frequency level of channel two. This

Use this to adjust the low frequency level of channel two. This

This switch, when engaged [right side down], enhances the