Brainworx Ampeg SVT-VR 플러그인 매뉴얼 - 페이지 6
{카테고리_이름} Brainworx Ampeg SVT-VR에 대한 플러그인 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brainworx Ampeg SVT-VR 10 페이지.
페이지 인쇄F X R A C K D y n a m i c s
(1) NOISE GATE:
'CLOSED' LED:
When lit this LED indicates that the Noise Gate is CLOSED. This means the THRESHOLD
setting is higher than the incoming bass signal and the noise gate dims the output
signal of the amplifier by the amount adjusted with the RANGE control (e.g. 15dB in
the picture above).
NOISE GATE ON/OFF:
Enable or disable the Noise Gate completely. Switch up ('on') means
the Noise Gate is activated.
THRESHOLD:
The Noise Gate will dim the output signal of the amplifier as soon as the
input signal (your bass signal) falls below a certain level. This level is called Threshold.
Adjust the Threshold so the noise of the overdriven amp will be reduced, but make
sure you don´t cut fading notes or chords.
RANGE:
The output level of your amplifier will be reduced or muted when the input
signal is lower than the Threshold setting. You may dim the output level only by a few
decibels (dB), or completely mute the output in pauses by setting the RANGE to its
maximum.
|
Ampeg SVT-VR
(2) AMP FILTERS (switchable pre/post)
TIGHT FILTER:
With the TIGHT filter you can cut LOW frequencies of either the DI bass
signal (PRE) or the processed amp output (POST).
PRE:
If your pickups produce an unintentional rumbling bass sound you can filter the low
end before the DI sound even hits the amplifier.
POST:
If you want to cut some of the low end of your amplifier setting (maybe even only
temporary) you can use this studio quality high pass filter to reduce the bass.
OFF:
When set to OFF the TIGHT filter is in bypass mode.
SMOOTH FILTER:
With the SMOOTH filter you can cut HIGH frequencies of either the DI
bass signal (PRE) or the processed amp output (POST).
PRE:
If your pickups catch a lot of hiss or noise you can filter the high end before the DI
sound even hits the amplifier.
POST:
If you want to cut some of the high end of your amplifier setting (maybe even
only temporary) you can use this studio quality low pass filter to reduce treble.
OFF:
When set to OFF the SMOOTH filter is in bypass mode.
6