AEV Bison 설치 매뉴얼 - 페이지 6
{카테고리_이름} AEV Bison에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEV Bison 12 페이지.
페이지 인쇄2.
Disconnect the leads labeled A, F1, and F2 and remove the Warn harness from the controller (fig. 10).
3.
Route AEV harness through the AEV bracket and into the controller through the same openings the
Warn harness was removed from.
Connect AEV leads. Yellow = A, Green = F1, Blue = F2
4.
5.
Isolate the small black motor ground wire inside the controller. Cut and splice in the new motor ground
wire from the AEV harness. NOTE: Make sure the splice will be located within the winch controller
enclosure when reassembled.
6.
Mount the controller to the bracket using QTY 2 flange nuts provided. (fig. 11).
7.
Reinstall QTY 4 bolts to reassemble controller housing.
A M E R I C A N
E X P E D I T I O N
A
F2
F1
Figure 10
Figure 11
V E H I C L E S
4